Want to master the operation skills of the intelligent asphalt spreader? Here is a detailed step-by-step guide to help you get started easily!
First, turn on the main air pressure switch, connect the power supply and start the computer.
2️ ️ go to the service menu, select Chinese, and then turn on the heating mode.
3️ ️ loosen the air door, close the empty door, and start the heating process.
4️ ️ turn on the oil pump, wait for a few seconds and then start the burner. Monitor the temperature and keep it at around 60 degrees.
5️ ️ when the temperature is suitable, start the spraying operation.
6️ ️ start the car, check the air pressure, and when it is appropriate, step on the clutch and engage the power take-off.
7️ ️ turn on the display, set the wind speed to 50 revolutions, start the large cycle, and let the filter oil pump work.
8️ ️ increase the rotational speed appropriately as needed, for example, 200 revolutions or 300 revolutions, to ensure that all the oil in the filter element oil pump is pumped into the heat transfer oil pipe.
9️ ️ turn on the nozzle and start the spraying operation.
🔟 After the work is completed, recover the asphalt, check the air pressure and replenish it if necessary.
1️ ️ 1️ ️ after three sprays, clean the nozzle.
1️ ️ 2️ ️ **, open the ball valve of the hand spray gun, select the wind speed of 30, and switch to pump out mode.
If the asphalt sprayed by the nozzle is not large enough, the wind speed can be adjusted, for example, to **50.

🎈 hope this guide will help you operate the smart asphalt spreader easily and handle various working scenarios!